Phone Numbers

Connect on Social Media

Use the links below to connect with us on Social Media.

Visit Us

Message Us

Steps to Solving Your Mold Problem

Inspection - Thorough visual inspection of all possible contaminated areas, attic, crawlspace, basement, HVAC and Duct System, floors, walls, ceilings.

Pre-testing and Analysis performed by AFTERDISASTER, an independent indoor air quality hygienist, prior to the start of remediation.

Containment and Protection of structure and contents not yet affected:

  • Limited: Use polyethylene sheeting ceiling to floor around affected area with a slit entry and covering flap; maintain area under negative air pressure with HEPA filtered fan unit. Block supply and return air vents within containment area.
  • Full: Use two layers of fire-retardant polyethylene sheeting with one airlock chamber. Maintain area under negative pressure with HEPA filtered fan exhausted outside of building. Block supply and return air vents within containment area.

Removal and safe disposal of unsalvageable materials (usually porous materials such as drywall, insulation and ceiling tiles).

High Efficiency Particulate Air (HEPA) Vacuuming of all surfaces

Wet cleaning of affected areas using detergents recommended for mold remediation.

Application of an antimicrobial approved by EPA for mold remediation.

Drying of the structure to safe moisture levels (determined by hygrometer measurement).

Final HEPA Vacuuming of all surfaces.

Clearance inspection and testing by AFTERDISASTER.

Removal of containment.

Copyright © 2017
All Rights Reserved
AFTERDISASTER-Metrolina

Connect with Us